Angle control valve has a wide application in industry,this is the brief introduction about angle control valve application.
Angle control valve is special single seat structure, which is suitable for specific piping and flow requirements, the inner side of the angle control valve body is streamlined.Angle control valve is specially designed for coking hydrocarbons and the streamline path design in the control valve body helps prevent solids blocking on the inner wall.Angle control valve has been used incorrectly under high pressure differential conditions in the past, the basic idea being to keep turbulence generated during throttling away from the control valve's internal parts, but doing so will result in energy conversion in the post-valve pipeline, and cause a serious pipe vibration and noise problems.
Another disadvantage of angle control valve : in most angle control valve application, a streamlined flow will result in higher pressure recovery.High pressure recovery means that the fluid medium has a low cavitation coefficient and severe cavitation at low or medium pressure.In addition to the special applications described above, Angle control valves can be used for piping where no straight through valves are allowed and to control certain abrasive fluids, such as abrasive catalyst materials.In the latter case, material is drained from the discharge pipe (side in and out of the bottom) to prevent abrasion inside the valve body.If it is inevitable that cavitation erosion and flash vaporization will occur, Angle control valve can be arranged to discharge materials directly into the container, so as not to damage the valve.